Technics SA-200

Description: Here is a great working Technics SA 200 vintage stereo receiver. I put real American Black Walnut veneer on it. Replaced lamps that were needed,cleaned all controls. All are working as they should , 100%. there are a few marks on one of the switches, there is a close up of it. There are some small marks on the face or knobs. Some are very hard to see but you can see them in the close ups. There not big marks so. look close. Since this is 40 plus years old. If your looking for a vintage receiver without the vintage price and in great shape. This one should work fine for you. Plus it doesnt weigh 100 lbs. So smaller and lighter in size then the normal one. But still has the sound and power that should work for you. It has the specs to back it up. There is no warranty but I do promise not to be doa. There is some tape residue on the back. If you scrub you might get it off. I didnt want to remove any of the lettering on the back. It will work when you get it and will be well packed, To much time in this to let someone destroy it in shipping. You can get the service manual that has all the specs and operation and repair in it at hifiengine.com. Please ask questions before you buy, make sure this is what your looking for. The receiver is 16 lbs and 17 wide x 12 deep x 5 5/8 tall. I do add security tape to the unit to prevent parts being taken out. If seal on the tape is broken, no refund at all. Parts or repair only. Sorry, do have to protect myself and the unit. thanks SpecificationsTuning range: FM, MWPower output: 25 watts per channel into 8Ω (stereo)Frequency response: 10Hz to 30kHzTotal harmonic distortion: 0.04%Damping factor: 32Input sensitivity: 2.5mV (MM), 180mV (DIN), 150mV (line)Signal to noise ratio: 78dB (MM), 95dB (line)Channel separation: 55dB (line)Output: 150mV (line), 30mV (DIN)Speaker load impedance: 4Ω to 16ΩDimensions: 430 x 142 x 300mmWeight: 7.2kgDownloads Not only have I been doing wood working for the past 20 years, and have a complete wood shop will all the major equipment. But I went to school for electronics back in 83 and got a diploma in it and that is what my normal 8 – 5 job is, and have also a personal complete electronics shop with all the test equipment. I am not someone that picked up a soldering iron one day on eBay or read the internet and all of a sudden I am an expert. Its also not what my dad did but what I do. Not living off someone else's credit but It’s what I do for a living. I have been to schools for all the major brands and authorized for most right now.

Price: 300 USD

Location: Loveland, Colorado

End Time: 2024-11-27T15:08:08.000Z

Shipping Cost: 8 USD