Description: 10 Inch x 4.5 Inch Iron / Manganese Water Filter Product Overview Iron manganese media, used for removing soluble iron (Fe) and/or manganese (Mg) as well as hydrogen sulfide (H2S) from well water supplies, is a purple-black filter media processed from ceramic zeolite granule. Iron manganese media can be used in a completely closed pressure system with no aeration or re-pumping, or in an open gravity filter system. The most common methods of operation are continuous regeneration, which is recommended for predominantly iron water. Physical Characteristics Apparent Density: 1.0 g/ml Specific Gravity: 2.5~2.6 Screen Grading (dry): 16~30 mesh Effective Size: 0.65 ± 0.05mm Uniformity Coefficient: Less than 1.5 pH Range: 6.2 ~ 8.5 Maximum Temperature: 25 C° Maximum Pressure Drop: 0.85 kg/cm2 Note: Customers are advised to use a "sediment filter" as a pre-filter and a "CTO filter" as a post-filter to extend the life of the "Iron Manganese" replacement cartridge as the Iron-Manganese filter woven gets clogged fast if not protected by a sediment filter first. Also, customers might experience a slight pressure drop in water output (the minimum inlet pressure for the iron-manganese system is 60 psi). Rest assured this is normal and a part of the functioning of the media cartridge. Material Safety Data Sheet Hazards Identification: Inhalation: Excessive concentrations of a nuisance dust may cause nuisance condition such as coughing, sneezing, and nasal irritation. Ingestion: Non-toxic. Large oral doses may cause irritation to the gastrointestinal tract. Skin Contact: Not expected to be a health hazard from skin exposure. May cause mild irritation and redness. Eye Contact: No information found, but presumed to cause mechanical irritation. Aggravation of Pre-existing Conditions: No information found. First Aid Measures Inhalation:Remove to fresh air. Get medical attention for any breathing difficulty. Ingestion:Not expected to require first aid measures. If large amounts were swallowed, give water to drink and get medical advice. Skin Contact:Immediately flush skin with plenty of water for at least 15 minutes. Remove contaminated clothing and shoes. Wash clothing before reuse. Thoroughly clean shoes before reuse. Get medical attention if irritation develops. Eye Contact:Immediately flush eyes with plenty of water for at least 15 minutes, lifting upper and lower eyelids occasionally. Get medical attention if irritation persists. Fire Fighting Measure Fire:Not considered to be a fire hazard. Explosion:Not considered to be an explosion hazard. Fire Extinguishing Media:Use any means suitable for extinguishing surrounding fire. Special Information:In the event of a fire, wear full protective clothing and NIOSH-approved self-contained breathing apparatus with full face piece operated in the pressure demand or other positive pressure mode. Accidental Release Measure Ventilate area of leak or spill. Wear appropriate personal protective equipment as specified in Section 8. Spills: Sweep up and containerize for reclamation or disposal. Vacuuming or wet sweeping may be used to avoid dust dispersal. Handling and Storage Keep in a tightly closed container, stored in a cool, dry, ventilated area. Protect against physical damage. Containers of this material may be hazardous when empty since they retain product residues (dust, solids); observe all warnings and precautions listed for the product. Exposure Controls and Personal Protection Personal Respirators (NIOSH Approved): If the exposure limit is exceeded and engineering controls are not feasible, a half facepiece particulate respirator (NIOSH type N95 or better WARNING: Air-purifying respirators do not protect workers in oxygen-deficient atmospheres. Skin Protection:Wear protective gloves and clean body-covering clothing. Eye Protection:Use chemical safety goggles. Maintain eye wash fountain and quick-drench facilities in work area. Physical and Chemical Properties/ Characteristics Appearance: Black Nodular Granules, Sand-like in Appearance Odor: No Odor Boiling Point: None Specific Gravity: 2.6 Vapor Pressure: N/A Percent Volatile by Volume: None Solubility in Water: 0% Vapor Density: N/A 10. Stability and Reactivity Stability:Stable under ordinary conditions of use and storage. Incompatible Material:Avoid contact with hydrochloric acid as gaseous chlorine may be produced. Hazardous Polymerization:Will not occur. Incompatibilities:Strong acids, fluorine, ammonium salts, magnesium with hydrogen. Conditions to Avoid:Avoid contact with concentrated hydrochloric acid (HCl).Toxicological Information Toxicological Information Effects of Overexposure:Inhalation – normal nuisance dust symptoms Eye Contact: Will act as irritant Ingestion: Non – toxic Skin Contact: No acute effects Threshold Limit Value:None Ecological Information Environmental Fate: No information found. Environmental Toxicity:No information found. Disposal Information: Whatever cannot be saved for recovery or recycling should be managed in an appropriate and approved waste disposal facility. Processing, use or contamination of this product may change the waste management options. State and local disposal regulations may differ from federal disposal regulations. Dispose of container and unused contents in accordance with federal, state and local requirements. Transport Information: Not regulated. Regulation Information: Not regulated. Other Information * The information provided is given in good faith and is based on our actual knowledge. * This is not a technical sheet for use of the product. * This sheet does not exempt the user from knowing and applying all the relevant regulations and from taking all the relevant safety precautions.
Price: 70 USD
Location: Niagara Falls, New York
End Time: 2024-08-24T16:53:09.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
Return shipping will be paid by: Seller
All returns accepted: Returns Accepted
Item must be returned within: 30 Days
Refund will be given as: Money Back
Model: 104110
Compatible Model: Max Water
Color: Blue
MPN: 104110
Brand: Max Water
