KENWOOD TKR750 TKR850 Repeater Controller Cable for YOUR GMRS or HAM system 36"

Description: Cable for connecting YOUR repeater controller to YOUR compatible Kenwood repeater This is the same cable we make in-house to use with our ID-O-MATIC repeater controllers.Now we offer this cable separately so you can interface YOUR controller to YOUR Kenwood TKR-750 TKR-751 or TKR-850 TKR-851repeater. As long as you have a good working TKR-x50 series repeater programmed internally for frequencies and PL and an external *controller, this cable will work properly If you want a complete plug and play solution WITH controller for your GMRS or HAM repeater, see our eBay store or use these below links CW VERSION https://www.ebay.com/itm/321447567516 VOICE VERSION https://www.ebay.com/itm/321447571469 THIS CABLE is 36 inches long We also make a 14" version of this cable, see our eBay store, see https://www.ebay.com/itm/143425558537 As of 11-20-23 we use shielded cable with full foil and runner connected to Black GND wireGenuine high quality DB-25 connector We use pin 24 on the DB-25 as COR (make sure you program your repeater or controller to match pin 24 COR active HIGH or active LOW)Wires in the jacket are genuine stranded (all copper), 36" longWires are stripped and ready for you to work with to attach to your controller (just as shown)Wires connected are (TO - IDOM4 green terminal block number in parenthesis): Black - Ground common (1 or 12) with shield Green - PTT (repeater needs active LOW - GROUND to transmit from your controller (3) White - Transmit audio IN (11) Brown (or Red or Yellow) - RX audio OUT (8) Blue - COR (7) (make sure you program your repeater or controller to match pin 24 COR active HIGH or active LOW) NOTE: * your controller should be a REAL controller, NOT one of those cheap Chinese controllers that does not use COR. Meaning: a VOX repeater system is NOT RECOMMENDED. DO IT RIGHT, use our ID-O-MATIC controller !What is COR? Carrier operated relay. In usual terms this means that when a VALID signal with the proper PL arrives at the receiver input, the COR line will "change state". In the case of the TKR-x50 series, the COR line will go from a "low" with no signal to a "high" with valid signal (or vise versa depending on how your repeater is programmed on pin 24 COR). It is this "change of state" that tells repeater controllers that a valid signal is there to be repeated. Can we make a custom cable for this repeater? Different length or some additional wires added? | This is possible for additional cost. send a message ask me what you want different. Can we make a custom cable for some OTHER radios or repeater? --- MAYBE --- BEFORE you ask me, YOU must research your radios or repeater and answer these questions: 1) For TX radio: Are there external connectors on the repeater or TX radio that have Mic hi (audio in) and PTT? 2) For RX radio: Are there external connectors on the repeater or RX radio that have audio out and COR? 3) Are the mating connectors COMMONLY available? If no to any above, then NO I cannot make a cable

Price: 37.95 USD

Location: Fort Collins, Colorado

End Time: 2024-11-28T23:21:58.000Z

Shipping Cost: 5.95 USD