Filter Attenuator | NanoVNA-F Vector Network Analyzer 10KHz -1.5GHz HF VHF UHF A

Description: Specifications Measuring Frequency: 10kHz ~ 1.5GHz RF output: - 13 DBM (maximum - 9 dbm) Frequency accuracy: < 0.5 ppm Port SWR: < 1.1 Display: 4.3 inch IPS TFT (800x480) USB Interface: USB Type-C Communication Mode: CDC (Serial) Power consumption: USB 5V 200mA, built-in 5000mAh battery, theoretical life of 18 hours, maximum charging current 2A Output capability: 5V/1A, supporting Android and Apple phones Number of calibration points: 101 Number of scanning points: 101 Package Content 1x NanoVNA-F host 4.3 inch (with Shielding protective film) 1x USB Type-C data cable 2x 20cm SMA male to male RG316 RF cable 1x SMA male calibration kit - OPEN 1x SMA male calibration kit - SHORT 1x SMA male calibration kit - LOAD 1x SMA-JJ male to male connector 1x SMA-KK female to female connector 1x SMA-JKW male to female right angle connector 1x RF Demo Kit [Evaluating and Learning Nanaovna] The RF Demo Kit is a NanoVNA RF test board independently designed by BH5HNU, with a size of 10*10cm / 3.94*3.94 inch. The demo calibration board for evaluating and learning nanaovna vector network analyzer, antenna analyzer test calibration learning, making sure your setup is working [Tiny but Mighty] This RF Demo Kit is integrated with 18 functional modules. Can be used to measure 30MHz short wave low-pass-filter LPF, 100MHz FM high-pass filter HPF, 433MHz commonly used SAW band pass filter BPF, 6.5MHz ceramic trap BSFtt [Note] The test parameters of the 18 patterns of the test board are described as follows. Two steps must be performed before testing: Step 1. Connect the two 20CM SMA to IPEX adapter cables to the NanoVNA-F machine. Step 2. Recalibrate the machine using the 13 Short, 14 Open, 15 Load, and 16 Thru circuits on the test board, and save the parameters to SAVE 0 [Applicability] It works with Nanovna-h / Nanovna-h4 / Nanovna-f / f v2 / f v3 / Nanovna saa-2n, and other nanovna antenna analyzer [Package Included] 1x PCB RF tester board, 2 x 20cm U.FL connectors (Be aware the connectors on the test cables that connect to the PCB are only good for a hand-full of connection/disconnection cycles before they break)

Price: 25.41 USD

Location: Brentwood, New York

End Time: 2024-11-17T11:19:20.000Z

Shipping Cost: 0 USD