DCT 8in Work Bench Holdfast Woodworking Hold-Down Clamp

Description: From small boards to large blocks, this DCT bench holdfast makes frequent clamping simple. It is an 8-inch clamp with a 4-inch reach and 5/8-inch shaft diameter to use with any bench thickness from 2.5 inches and up. It can be used in applications where you need to consistently shift your workpiece such as in carving, routing, sanding, finishing, and general woodworking jobs. The rough stem and uniquely hooked profile offer a strong hold on difficult workpieces. To use, drill a vertical 3/4-inch hole in your workbench top and drop the holdfast in place. When the arm contacts the top of your stock, give the holdfast head a firm tap until it jams tightly in the hole. To disengage your work from the clamp, tap the backside of the vertical shaft to unjam from the hole and release your work. WARNING: This product can expose you to chemicals which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov. QUICK AND EASY CLAMPING: Use this DCT Holdfast on your workbench to quickly shift and adjust your woodworking stock with its quick clamping and quick release design USE ON YOUR WORK BENCH: 8-inch (20.3cm) clamp has a 4-inch (10.2cm) reach and 5/8-inch (17mm) shaft diameter to use with any bench thickness from 2.5 inches (6.4cm) and up VARIOUS APPLICATIONS: For applications where you need to consistently shift your workpiece; Carving, routing, sanding, finishing, and general woodworking jobs; Rough stem and uniquely hooked profile offers a strong hold on difficult workpieces EASY TO USE: Drill a vertical 3/4-inch (1.9cm) hole in your workbench top to accommodate the holdfast and drop it in place, when arm contacts top of your stock board, give holdfast head above the top of round shaft a firm tap with a wooden mallet or rubber hammer until it jams tightly in the hole to hold your work firmly; When you are ready to disengage your work from the clamp, tap the backside of the vertical shaft of the holdfast opposite the arm to unjam from the hole and release your work HELPFUL TIPS: Holdfast will not hold if it is too loose in the dog hole or if your bench top is not thicker than 2.5 inches (6.4cm); If you extend the holdfast too high in an effort to hold something that is out of its working range, it will not be able to develop enough of a bind in the dog hole and will be loose; We suggest using a scrap of wood as a pad between the holdfast and the workpiece so the holdfast can be tapped hard without damaging your stock

Price: 24.51 USD

Location: Buford, Georgia

End Time: 2024-11-16T02:45:23.000Z

Shipping Cost: 0 USD