BMW Euro Motor S50B32 Engine For M3 E36 IN CAR RUNNING 6 SPEED UUC LOTS MORE!

Description: I have a Mint complete RUNNING S50B32 EVO AND GETRAG 420 6 SPEED MANUAL IN my 1994 325i,that was formerly owned by UUC MOTORWERKS /or their associate. It has a good amount of UUC MOTORWERKS PARTS,M5 CLUTCH SET,Short Shifter,Rebuilt LSD,H&R Lowered Springs,Turner Motorsports Adjustable Sway Bars,Team Dynamics Motorsports Pro Race 1.2 Wheels in 17x8 Square with ET40 offset ,May have spacers behind the wheels.No Center Caps.Harness and DME are for the EVO. Running through the stock 325i Muffler.Real Sleeper! In Carlstadt NJ Additional Full Floating Disc Brakes,Hawk Pads,M3 Calipers and Brackets and Stainless Steel Hoses may be available to buyer. UPDATE! 05/17/2024 A Compression Test was performed on the engine,at request of a potential buyer, and it was done using a Brand New Compression Tester,as I needed to use a 12mm x1.25 Threaded Adapter. Engine was observed in approximately 65 Ambient Outside Temperature, and done with All (6)Spark Plugs removed, and engine wasn't started prior,yielding an almost consistent 120-127 PSI on All (6), but, I was not sure if throttle should have been open for this test. Tomorrow,05/18/2024 I will go back to the car, and this time I will be Running it,prior to testing,up to operating temperature,then I will remove the Coil Packs and Spark Plugs, and set the Throttle as Wide Open, and retest the Compression and see what I get.I did speak with several professional ASE Master Techs,as well as a few Engine Builder Shops I have previously worked for,for their opinions on what is an acceptable method and Compression Values that I should be getting. This in no way is indicating anything amiss about this engine ,but,was requested in lieu of lack of records prior to my acquisition of it.

Price: 19500 USD

Location: Carlstadt, New Jersey

End Time: 2024-12-22T02:02:11.000Z

Shipping Cost: N/A USD